"Digested sludge lagoons were originally considered temporary sludge storage devices; however, it was found that with prolonged storage a lagoon became an effective drying unit. Since they provide one of the more economical ...

"The elastic modulus of concrete is an important parameter in reinforced concrete design and analysis. With the increased use of lightweight aggregates for structural concrete a better understanding of the relationship ...

The absorber considered in this paper consists of a single layer of lossy dielectric material backed by a good conductor. It is assumed that both the magnetic and the electric dissipation factors of the dielectric may be ...

This map, drawn by Ralph C. Arnhold, shows the locations of offices and buildings on the University of Missouri campus via an alphanumeric grid....

reduce the number of circuit elements needed to represent a part of the system which is not to be analyzed in detail, but must be accounted for as it affects the remainder. Sometimes it is found that commonly used equivalents do not correctly represent...

The mutual impedance of two coupled linear antennas is needed to obtain the radiation impedance of an array of linear antennas and to determine the effect of one antenna upon a neighboring antenna, for example, the effect ...

"A series of stiffened shells made of plastic were tested to verify the theoretical equations for the effect of edge conditions on the buckling of stiffened and framed shells. The theory was developed by calculating the deflections during loading...

This map shows the locations of buildings on the University of Missouri campus, labeled by number and letter....

"This paper presents the procedures used and the results obtained in a series of static load tests designed to study the mechanism of load transfer between adjacent precast bridge-slab sections. These tests were undertaken as one phase of a general...

A finite difference equation is developed for the stream function in cylindrical coordinates with axial symmetry which is applicable to an irregular mesh having different length and radial dimensions. In addition, the ...

Formulas are derived for several cases of loosening of bolted joints caused by stresses in excess of elastic limits and accompanying permanent deformations. It is shown that loosening occurs during the initial application ...